Snow Foam: Everything you need to know

Snow Foam? Nano Tech Cleaner? Snow Foaming? - Confused? Not sure which tool is right for your clean? We are here to help make things a little easier to follow!

Picture this – you arrive home from an epic ride out on your motorbike, car, bike or even UTV and you know your ride is dirty. You’re planning a big Clean, Protect and Lube job with your Muc-Off Motorcycle Specific Pressure Washer and a bundle of products and can’t wait to get started.

You go out to your garage and realise just how mucky things have got. We’re not just talking a smattering of dirt – we’re talking full on FILTH (just how we like it). If you’re crusted up to your handlebars or steering wheel in thick grime, dirt and mud then you’ll be needing Snow Foam.

snow foam for motorbikes and cars

Why use Snow Foam?

So, why use Snow Foam and not start with our Nano Tech Motorcycle Cleaner? Technically – you need both of these to do the job, but Snow Foam is actually a pre-treatment. Our detailing experts have produced a formula that significantly reduces the possibility of damage to paintwork as it breaks own heavy dirt and grime in preparation for a full clean down.

The formula in Snow Foam is pH neutral and water-based, designed to soak and saturate soiled paintwork whilst protecting wax, sealant or polish. It works best when used with our pressure washer where you simply screw the bottle to the snow foam lance and blast all over your ride for maximum coverage. Once you have completely covered, leave it to work for a few minutes and rinse away with the motorcycle specific lance.

When the thickest dirt has melted away – then switch to the Nano Tech Motorcycle Cleaner to finish your full clean. Our bottle of pink stuff is powered by science – it’s the only cleaner that uses nano technology to ensure the deepest clean at a microscopic level (techy – we know!)

snow foam for motorbikes and cars

It’s safe on all parts and surfaces, safe on seals, cables and brake pads and is biodegradable – so it’s great for your bike while being good to the environment! Use it in the same way as Snow Foam, screw into the lance, spray, agitate and rinse. Then you can get on with the fun stuff… detailing!

So there you have it. Use Snow Foam to melt away thick and heavy dirt, then Nano Tech Cleaner to finish things off.

For mid-level dirt, using just the Nano Tech Cleaner should cover you! If in doubt – snow foam it out!